Flowmaster - Flowmaster Pre-bent TailpipesThese Builder Series tailpipes are constructed from 2. 50 inch mandrel bent 16 gauge aluminized steel tubing for maximum flow, tuck up high in the chassis for good clearance and exit straight out the back under the rear bumper. Designed to be used with Side Inlet Center Outlet mufflers such as part# 942546 (Super 44 Series) or 942551 (50 Series) mufflers. Covered by our 3 year Limited Warranty. Note: Not designed to fit in factory bumper cutouts. Some
Fitting - Hose End - AQP/Startlite - Straight - 16 AN Hose to 16 AN Female - Aluminum - Blue / Red Anodized - Each
Carburetor - AVS2 - 4-Barrel - 500 CFM - Square Bore - Electric Choke - Mechanical Secondary - Dual Inlet - Aluminum - Tumble Polished - Each
When the vacuum pump is removed
Camshaft / Lifters - Performer RPM - Hydraulic Flat Tappet - Lift 0
Bumper - Post - Braces - Rear - 1 in Tube - Stainless - Natural - Sprint Car - Each
Lambda Controller - LCU1S - CANbus Output - Bosch LSU 4
Fitting - Adapter - 90 Degree - 4 AN Female Swivel to 4 AN Female Swivel - Aluminum - Black Anodized - Each
Includes all necessary hardware and easy to follow instructions
50 Thread - 65 mm Long - 12 mm 12 Point Head - Chromoly - Black Oxide - Universal - Set of 5
5 in Diameter - 1-3/8 in x 10 Spline - Rigid Hub - Sintered Iron - Universal - Each
Fitting - Adapter - 90 Degree - 10 AN Male to 3/4 in NPT Male - Aluminum - Black Anodized - Each
Voltmeter - Ultra-Lite - 8-18V - Electric - Analog - Full Sweep - 2-1/16 in Diameter - Peak and Warn - Silver Face - Each
