M20 x 2.5mm Metric Split Die Rethreading Thread Cutter Tungsten Steel 50mm Lines

M20 x 2.5mm Metric Split Die Rethreading Thread Cutter Tungsten Steel 50mm LinesProfessional Die for commercial or occasional use Right handed threaded die Suitable for rethreading as well as starting a new thread M20 x 2. 5mm rethreading Die M20 Die with 2. 5mm pitch 50mm width of the die so suitable for use with 38mm die holder Manufactured from tungsten steel for maximum strength and durability Tungsten steel is a more professional material and is a lot harder than the standard carbon steel dies Suitable for use on most

8mm x 42mm R Clips

A stern tie is used to reduce anchor swing in tight mooring areas

Tyre Valve Connector: Euro Clip On End

AIR PRESSURE - 90psi

and is approximately 22 cm wide

Helping hands tool featuring a round

- Bore (centre hole) size - 22

Rinse the tank after use

Complete with safety cut off switch (overload switch)

ensuring it's readily available whenever you need it

ideal for daily use on commercial and agricultural vehicles

UK 3 pin plug to IEC C13