Jeep Wrangler 2007 to 2010 Rear Glass with Molding Bronco

Jeep Wrangler 2007 to 2010 Rear Glass with Molding BroncoBare rear glass for JK J30 Gen 1 and Gen 2 J30 Campers. Includes lower molding, but not other hardware (hinges, hinge covers studs for strut, wiper motor parts, gaskets.) Light green tint No defrost grid Glass measures 42"x 20" Check measurements before ordering to insure proper fitment.

A new antenna is then glued on the windshield in the upper left corner

You will also need to unbolt and hoist the J30 off of a JK series Jeep a few inches to be able to reach under the camper and install the nuts and bolts

low weight and fast set up remain the same as our Jeep series

some stock may be available on a special order basis to add to an order

gear and supplies can increase total vehicle weight beyond limits set by Jeep

Reservation holders that configured a camper and placed an order have the highest production priority

Ursa Minor Vehicles - Rear Awning Mount kit for the J30 JK Camper / Gen 2

To learn more about this table

The weight of the J30 camper can change due to the options added as well as due to variations in manufacturing

Weight: 1 lb 10 oz

which is why it takes us a bit longer to deliver it to you

no options 290 OEM Hard Top 125 Net increase in vehicle weight