Pulsar Turbo Systems - 7982G Curved Point Mill Compressor Wheel Dual Ball Bearing Turbocharger Manufacturer_Bullet Race Engineering

Pulsar Turbo Systems - 7982G Curved Point Mill Compressor Wheel Dual Ball Bearing Turbocharger Manufacturer_Bullet Race Engineering6+6 Blade, New design Curved point mill billet compressor wheel which can obtain the most mass flow through the curved vanes and allow increases in engine horsepower output Dual ceramic ball bearing system provides optimal turbo response & better durability by reducing the shaft motion 9 Blade G Aero Inconel 713c turbine wheel Anti Surge ported shroud compressor inlet, cover integrated with the speed sensor and pressure ports Water fittings included

Coil Bind 24

Delivered Ford XR6 turbo

Driver Side Window Arm / Lever Unit to suit Nissan Skyline R33 GTS / GTST / GTR

Seals gasket surfaces without adhering

7-1/2" (190mm) High x 6" (153mm) Base O

This gearbox comes with both a limited Nissan Warranty and a TSS Start up warranty to ensure you do not have ANY problems with your brand new gearbox

which can be seen here: https://au

The front lines are also longer to compensate for big brake setups or cars with more steering lock (which would see stretching with the factory line)

Notes: CAN Cable - DT-4 to DTM-4 Adaptor- Suits CAN Keypad - 200mm

if you are doing a manual conversion and you don't want to run the bulky factory damper system or if you wanted to have things less complicated and clean up the appearance then you would select the damper delete option

For those that would prefer to utilise AN style fittings

Size 4 6 8 10 12 14 16 Half Chest 40 44 48 50 52 55 57