XTool P2 (Flange) To 4 Inch (101mm) Hose Adapter craftsman

XTool P2 (Flange) To 4 Inch (101mm) Hose Adapter craftsmanBuild your custom smoke and fume extraction system with hose adapters allowing you to transition to different hose sizes. This part allows you to connect a 4 inch (~101mm) hose to the back of the XTool P2 (flange) for the purpose of smoke and fume extraction of your laser cutter and engraver. NOT COMPATIBLE WITH P2S This would replace the small black flexible hose and flange that comes with the XTool P2 so you can use a more common 4" duct style hose

It is easy to tell them apart since the larger 16mm rods are metal

then you can use one of my AP2/IF2 to 4 inch hose adapters to achieve that

This kit mounts the main assembly on top of the T-slot profile and allows you adjust the center of mass above the base so that there is no risk of the assembly tipping over

TFT touch screen)

A direct drive extruder is far superior and the Bondtech LGX Lite combines precision and low mass to achieve a fantastic direct drive solution

The entire spool holder is reinforced with a steel bolt running through the center of the part that prevents the part from creeping / sagging over time

this set features 30 essential screwdriver bits

To use this kit you will need to buy the V1 extruder that has the removable plate between the extruder and the motor

Creality Enclosure (Laser enclosure picture is for reference)

The RA2 base can slide under and will sit against the riser feet to provide an easy method of aligning the center axis of your cylindrical workpiece with the center of the laser

Many laser engraving machines (ie

All lead screws are synchronized with the pulley block system at the bottom of the printer