Clipper Number 51 Brush Drive System Upgrade Links per Model:62 links (for 9 series cleaners)

Clipper Number 51 Brush Drive System Upgrade Links per Model:62 links (for 9 series cleaners)This is an upgrade kit for the Clipper Number 51 brush drive system. This kit upgrades the old number 51 detachable link chain to the modern number 60 roller chain. There are 3 variations for this kit depending on the series of cleaner you are running. 7 series cleaners (any cleaner with the model number ending in 7) require 50 links of number 60 chain (including the attachment link). 9 series cleaners (any cleaner with the model number ending in 9)

All Eliminator seed cleaners and most Clipper M-2B seed cleaners require two of these (one under each screen) however some Clipper M-2B seed cleaners were made with only one carrier under the bottom screen

20x48 = 400-550

These sprockets are also used on Clipper M-2Bs that have the updated cable kit installed on the older brush drive system

The clipper part numbers are F030-15503 and F030-16510

If you receive this shaft and it is longer than you original belt tightener shaft you will have to cut it down

Eccentric bearing for E224

These are the wide belts that are used to adjust the speed on Clipper Seed Cleaners

It is also used on Clipper M-2B seed cleaners that have been updated from a 13/16 fan shaft to a ¾ shaft

This bushing goes on the discharge end of the auger tube

* complete set of enclosed belt guards

The shaft length is 28

So please make sure you are ordering the correct size length