ENGINE BEARINGS - 205 Position:Big Ends (STD)

ENGINE BEARINGS - 205 Position:Big Ends (STD)Model: 1. 6L GTI & 1. 9L GTI Thrust Bearings: For housing diameter from [mm]: 83,05 To housing diameter [mm]: 83,3 For wall thickness from [mm]: 2,330 For shaft diameter from [mm]: 67,05 To shaft diameter [mm]: 67,3

offering a weight saving of approximately 45% compared to equivalent steel bolts

Capacity: 2L

Model: R26/225

By tweaking front and rear damping you can adjust the way the car handles

Thrusts between 1 & 2 lobes

Remove your stock oil pressure sensor

Winning a race requires great concentration from the driver

this solution is highly beneficial when welding is not feasible

Please retorque the studs and nuts after a few heat cycles to prevent them from loosening

Wear warning contact

If you are unsure of any of the steps below

Simple and easy to install