IMSA WeatherTech Fuel Flow Team CAN Interface RaceGrade

IMSA WeatherTech Fuel Flow Team CAN Interface RaceGradeFor IMSA Weather Tech participants only. This loom allows teams to connect to the sensor and log view the CAN data in real time. Teams will need to contact Sentronics to have the team port enabled on their sensor, CAN data does not get transmitted without the software update. Loom has 1x 120 ohm Terminating resistor installed. Teams connect to this harness using a DTM06 2S connector: Pin 1 CAN Low Pin 2 CAN Hi

terminated I/O Loom is available

Weighing in at only 481g for the ZD202-2

Pair Of Single Paddles

plug-in display solution based on our new full colour C1212 Display

and will start monitoring these

• Weight 300 g

COMES ENABLED WITH LOGGING AND I/O AT NO ADDITIONAL COST

Just mount your keypad to this piece and mount that into your application

It is a compact open-loop test system for quality assurance of control unit development and combines the simulation of all typical automotive sensors and communication protocols in one unit

- Choice of either 7 low side drivers or 5 low and 2 high side drivers

D Series displays* are enabled as standard while C series display loggers require an upgrade

Deutsch is continually assessing the requirements of the ever demanding world of motorsport